Copper Nickel Alloy CuNi2 (NC005) wire for Resistance
CuNi2Si - UNS.C64700/C70250 Nickel Silicon Bronze Alloys, which is an age-hardening alloy, higher alloyed in comparison with CuNi1.5Si, for current-carrying formed parts. It has an a-structure with very fine precipitations and recommends itself both for lead frames which require a high rigidity of the pins and for connector with high demands on the electrical conductivity, strength and relaxation behavior. In addition, the CuNi2Si can also be used for current-carrying formed parts and contact springs due to its good fatigue strength, forming and spring properties.
Typical Application for C64700/C70250 Nickel Silicon Bronze Alloys:
Electrical : Resistance Welding Electrodes, Motor Rotor Bar, And Resistance Welding Tips.
Fastener : Fastener parts
Industrial : Brazing Rod, Welding Rod
Available Products (forms):
Round bars, Flat bars, Square bars, Rectangular bars, Hexagon bars
Custom shapes are available upon request.
Chemical Content, %
| Ni |
Mn |
Fe |
Si |
Cu |
Other |
ROHS Directive |
| Cd |
Pb |
Hg |
Cr |
| 2 |
- |
- |
- |
Bal |
- |
ND |
ND |
ND |
ND |
Mechanical Properties
| Max Continuous Service Temp |
200ºC |
| Resisivity at 20ºC |
0.05±10%ohm mm2/m |
| Density |
8.9 g/cm3 |
| Thermal Conductivity |
<120 |
| Melting Point |
1090ºC |
| Tensile Strength,N/mm2 Annealed,Soft |
140~310 Mpa |
| Tensile Strength,N/mm2 Cold Rolled |
280~620 Mpa |
| Elongation(anneal) |
25%(min) |
| Elongation(cold rolled) |
2%(min) |
| EMF vs Cu, μV/ºC (0~100ºC) |
-12 |
| Micrographic Structure |
austenite |
| Magnetic Property |
Non |
Application of CuNi2
CuNi2 low resistance heating alloy is widely used in low-voltage circuit breaker, thermal overload relay, and other low-voltage electrical product. It is one of the key materials of the low-voltage electrical products. The materials produced by our company have the characteristics of good resistance consistency and superior stability. We can supply all kinds of round wire, flat and sheet materials.
International Specification:
Rods/Bars/Plates/Sheets: UNS.C64700, UNS.C70250, RWMA Class 3
European Standards: CuNi2Si, DIN 2.0855, CW111C to EN
Note:
ASTM: American Society for Testing and Materials
RWMA: Resistance Welder Manufacturers' Association
Note: Unless otherwise specified, material will be produced to DIN & RWMA
